Project Spotlight · Mandarin — Jacksonville, FL 32223
Wood Repair, T1-11 Siding Replacement & Exterior Painting in Mandarin, Jacksonville FL 32223
Twenty Years of Wear Couldn’t Be Solved With Another Coat of Paint
After roughly two decades of deferred exterior maintenance, this Mandarin home in Jacksonville, FL 32223 needed considerably more than another coat of paint. Aging T1-11 siding, deteriorated exterior wood, failed caulking, heavy oxidation and chalking, and years of accumulated exterior wear all had to be addressed as part of the project.
A New Leaf Painting Contractors approached the project in the order the house required: clean and evaluate the exterior, remove and replace deteriorated materials, complete the necessary wood and siding repairs, prepare and seal the remaining surfaces, and only then begin the exterior coating system.
Sherwin-Williams® Latitude® Exterior was used for the completed exterior painting. The photographs on this page are real project documentation from our crew.
Project at a Glance
Project
Exterior Repair, Siding Replacement & House Painting
Location
Mandarin
Jacksonville, FL 32223
Property
Residential Home
Condition
Approximately 20 Years of Deferred Exterior Maintenance
Existing Siding
T1-11 Siding
Replacement Siding
James Hardie® Siding Where Required
Wood Repairs
Deteriorated Exterior Wood Replaced Where Required
Preparation
Pressure Washing · Heavy Oxidation/Chalking Removal · Caulking · Surface Preparation
Coating
Sherwin-Williams® Latitude® Exterior
Project Type
Repair + Preparation + Exterior Painting
Contractor
A New Leaf Painting Contractors
Twenty Years of Exterior Wear
The before photographs document a house that had been left alone for a long time. The existing coating had oxidized and chalked heavily. Caulking at joints and transitions had aged and failed. Sections of T1-11 siding and exterior wood had deteriorated past the point where a coating would have done anything useful.
That last distinction is the one that shaped the whole project. Not every weathered surface needs replacing — plenty of aged material can be properly cleaned, prepared, and recoated. But material that has actually deteriorated is a different situation, and telling those two apart is most of what an evaluation is for.

Coating over unsound material does not correct what is underneath it. It conceals the condition for a season or two and then the same problem reappears through a new finish.
Why Painting Wasn’t the First Step
A repaint changes the coating. That’s all it does.
It does not replace failed siding. It does not restore deteriorated wood. It does not make loose material sound. It does not correct failed caulking. And it does not remove heavy surface contamination on its own.
Paint can protect a properly prepared exterior. It cannot make deteriorated siding or failed wood sound again.
So the project began with the exterior itself rather than with the coating. Everything that follows on this page happened before the first gallon of finish paint was opened.
Removing Old T1-11 and Replacing Failed Exterior Materials
Where T1-11 siding and exterior wood had deteriorated beyond a condition that should simply be coated, the affected materials were removed and replaced as part of the repair scope. James Hardie® siding was installed as the replacement material in the sections included in that scope.
This is where the project stopped being a painting job and became a carpentry job for a while. Our wood and siding repairs before painting work exists for exactly this reason — a coating system needs a suitable surface, and on this home a portion of that surface had to be rebuilt before it existed.

Field Note: When Should Old T1-11 Be Repaired Instead of Painted?
The decision should be based on the actual condition of the siding, not on its age.
Weathered but sound T1-11 can often be cleaned, prepared, and coated. Material that has deteriorated beyond a suitable paintable condition needs repair or replacement before a coating goes over it.
The scope should be determined by what is actually found on the house.
James Hardie Siding as Part of the Repair Scope
James Hardie® fiber-cement siding was used as the replacement material in the repaired sections of this Mandarin exterior. It was specified for this project as the material going into those areas — not applied across the entire home, and not as a claim about what every T1-11 house should become.
Replacement siding also has its own preparation requirements before coating, which is covered in our guide to painting James Hardie siding.

Pressure Washing Years of Oxidation and Chalking
Chalking is what happens when UV breaks down the binder holding an exterior coating together. The pigment releases as a loose powder that transfers to your hand when you run it across the wall. After twenty years of Northeast Florida sun, this home had it heavily.
Pressure washing and exterior cleaning were part of preparing the surfaces. Worth being accurate about what that does and doesn’t accomplish: washing removes accumulated contamination and loose material, but it doesn’t necessarily strip every trace of chalk from every surface, and the appropriate pressure and method vary by substrate. Heavy pressure applied indiscriminately damages some materials.
The paint color is what homeowners see at the end. Surface condition is what determines whether the project was ready for paint in the first place.
Failed Caulking, Joints & Exterior Openings
Two decades of exposure had left caulking that no longer did its job. Sealant hardens, shrinks, splits, and separates under sustained UV, and once it does, joints and transitions are open.
Deteriorated caulk was removed and joints, transitions, and penetrations were sealed as part of the preparation scope — not painted over.
What caulk does not do is waterproof a wall or substitute for flashing, and it shouldn’t be forced into every visible gap indiscriminately. It’s one component of exterior preparation, applied where the detail calls for it.
Preparing the Repaired and Existing Surfaces
By this point the exterior was a mix of conditions: original surfaces that had been cleaned and prepared, newly installed replacement siding, repaired wood and trim, freshly sealed joints, and existing coatings of varying age.
Those all had to be brought to a consistent, properly prepared state before finish coating. New replacement material and older existing surfaces don’t necessarily receive a coating the same way, which is one reason proper preparation matters before the finish system is applied.

Sherwin-Williams Latitude Exterior
Sherwin-Williams® Latitude® Exterior was the coating used across the painted exterior surfaces on this project.
It’s worth stating plainly what the coating did and didn’t do here: it finished a repaired and prepared exterior. It didn’t fix the deteriorated wood, replace the failed siding, or correct the caulking. All of that happened first. That sequence is the reason the finish has something sound to sit on. More on how we approach professional exterior painting across Northeast Florida.
The Finished Mandarin Exterior
The after photographs document more than a color change. They show replacement siding integrated into the existing exterior, repaired wood and trim, sealed joints, and a consistent finish across surfaces that started the project in very different conditions.
The meaningful transformation on this project isn’t old color to new color. It’s a neglected and partially deteriorated exterior brought back to a repaired, prepared, and properly coated one — in that order.
What This Project Shows About Painting an Older Exterior
An older or long-neglected exterior shouldn’t automatically be treated as a repaint-only project — and it shouldn’t automatically be treated as a full replacement either.
The right scope depends on the actual condition of the siding, how far any wood deterioration has gone, the state of the existing coating, how heavily the surface has chalked, whether caulking has failed, what the substrate is, and what preparation the surfaces genuinely require.
Some homes need straightforward cleaning and preparation and nothing more. Others need real repair work before a coating is appropriate. This Mandarin project fell firmly into the second category, and the evaluation is what established that — not an assumption based on the home’s age. For more on exterior conditions and preparation, see our Exterior Painting Resource Center, including what heavy chalking means before a repaint.
More Real Project Spotlights
See how different exterior surfaces, repair conditions, and coating systems change the scope of a painting project.
- Stucco repair and exterior painting in Jacksonville 32246 — conventional stucco, localized delamination, damaged substrate repair, and exterior painting.
- Synthetic stucco exterior painting in Coastal Oaks, Nocatee — synthetic stucco painted with Sherwin-Williams® Duration® Exterior.
- Exterior house painting in Coastal Oaks, Nocatee — James Hardie® lap siding painted with Sherwin-Williams® Emerald® Exterior.
- Exterior stucco painting in Jacksonville 32257 — extensive stucco preparation and a substrate-specific exterior coating system.
Planning a project of your own? Explore our professional exterior painting and exterior wood and siding repair services for Jacksonville and Northeast Florida homes.
Planning an Exterior Project That Needs More Than Paint?
Some exterior painting projects begin with washing and routine preparation. Others reveal deteriorated wood, damaged siding, failed caulking, or surfaces that need repair before they should be coated.
A New Leaf Painting Contractors provides exterior painting along with wood and siding repair for homes throughout Mandarin, Jacksonville, and Northeast Florida.
Explore Exterior Painting Services Explore Wood & Siding Repairs Request an Estimate
Or call or text 904-615-6599.
A New Leaf Painting Contractors
Serving Mandarin, Jacksonville, Duval County, and Northeast Florida since 2001.